Roland JUNO-60

<Tape Interface>
The Juno-60 features the Tape Interface system which allows its patch programs to be saved into an ordinary tape recorder. Therefore, countless tone colors can be ready to be used.

Tape Interface

Operations:

Saving (the patch program into a tape recorder)
  1. Set the tape recorder to REC (recording mode).

    record / play diagram


  2. Press the SAVE button (6) of the Juno-60.

    Save button


    The SAVE indicator will light up and the program number shown in the Display window will go out. Also, the Pilot tone will be sent from the SAVE jack.


  3. If your tape recorder features the recording volume adjust knob, adjust it so that the Pilot tone registers near 0 dB.

    0 VU meter


    In 4 or 5 seconds the Juno-60 produces a Modulated tone, i.e. saving into a tape recording begins. (Be sure to complete adjusting the recording level before the Modulated tone is heard.
    • If the SAVE indicator goes out and the Program Number Display window double-dash (- -) (Manual Mode), saving is completed. (All this takes approx. 50 sec.)


    * If you wish to stop saving in the middle, press the MANUAL button (4).

  4. Stop the tape recorder.


<< Table of Contents | Next (Verifying) >>