- Set the tape so that it will be played back
from the very beginning of the recorded
Data (where you hear the Pilot tone).
* If you use a tape recorder with the play back volume,
set it to about a medium level.
- Set the tape recorder to PLAY (playing mode) and
press the VERIFY button of the Juno-60.
- The VERIFY indicator lights up and the
Program Number Display window will go out, i.e. the
recorded Data will be sent back and its accuracy will
be checked.
- Press the VERIFY button before the Modulated tone is heard.
- If the VERIFY indicator goes out and the
Program Number Display window shows the double-dashes (- -),
verifying is completed. (All this takes approx. 50 sec.)
* If you wish to stop verifying in the middle,
press the MANUAL button (4) of the Juno-60.
- Stop the tape recorder.
* If there is an error in your recorded Data,
the Program Number Display window will show Er (Error).
If there is an error...
Repeat the Verify procedure taking care of the following
points:
- Be sure to press the VERIFY button whilst the Pilot tone is heard.
- Be sure to adjust the playback level of the tape recorder.
- Check if connections are made correctly.
If there was an error in the very beginning of
the Verify procedure, particularly take care of #1 above.
If the verify procedure did not complete even after 1 minute,
#2, #3 are particularly required.
* If the above procedures were all correctly done, it is
likely that there is something wrong with the tape.
If the error (Er) is again indicated...
Carefully repeat the Save procedure.
If the error is indicated again and again no matter how many times you try...
- Replace with a new tape.
- Clean and demagnetize the head of the tape recorder.
- Use a different tape recorder and repeat the same procedure again.
Preserving the Data Tape...
Please do not keep the Data recorded tape in a place of
high temperature or humidity or near a strong magnetic field
such as a speaker or amplifier.
|